FloodStop For Dishwashers & Toilets
Protect Your Property Against Water Damage
Prevent water damage from failed Dishwasher or
Toilet and Supply Line:
Dishwasher leaks are often small and go unnoticed until significant damage is
finally discovered. Such a leak will continue to collect under the Dishwasher
and then seep between the kitchen flooring and sub-flooring. The damage often
goes undetected until the floor is visually buckled or warped, at which time the
damage and cost to replace is extensive.
Toilet overflows can be the cause of significant property damage. The actual
overflow event typically takes a couple minutes to begin and often goes
unnoticed long after the occupant as left the bathroom.
FloodStop (FS 3/8-C) automatically shuts off the water supply to the Dishwasher
or Toilet, whether caused by a small continuous leak, broken component, leaking
seal, overflow or a ruptured supply line. Powered by AC Adaptor/Transformer or
Batteries. Output contacts available, which allow the Controller to connect with
Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in
ten minutes.
FloodStop (FS 3/8-C) Components:
• Motorized Ball Valve (3/8 inch Compression Fitting)
• Control Unit (with Battery Backup 4 X C Size)
• Water/Leak Sensor (1.25” X 7.5”)
• AC Power Adaptor (or use 4 X C Batteries as Primary Power Source)
• Output Contact Wires (2)
How FloodStop (FS 3/8-C) Works:
• The FloodStop valve is connected to the angle stop and supply line
• Water/leak sensor is placed at the base of the appliance or fixture
(Dishwasher – Toilet – 3/8” Icemaker – etc.)
• Valve stays open until water loss is detected
• Water on sensor closes FloodStop valve and sounds alarm
• Valve stays closed until problem is attended to and system is reset
|
