Call UsShopping Cart
No Sales Tax (except California)
Free Shipping On Many Items!
Call Toll Free 1.888.845.6597
Shopping Cart
Home > FloodStop Systems > FloodStop 3/8-C For Dishwashers And Toilets

FloodStop 3/8-C For Dishwashers And Toilets

OnSite Pro Inc.
FloodStop Systems
FloodStop 3/8-C For Dishwashers And Toilets

FloodStop For Dishwashers & Toilets
Water Leak Detection System - Protect Your Property Against Water Damage

Prevent water damage from failed Dishwasher or Toilet and Supply Line:

Dishwasher leaks are often small and go unnoticed until significant damage is finally discovered. Such a leak will continue to collect under the Dishwasher and then seep between the kitchen flooring and sub-flooring. The damage often goes undetected until the floor is visually buckled or warped, at which time the damage and cost to replace is extensive.

Toilet overflows can be the cause of significant property damage. The actual overflow event typically takes a couple minutes to begin and often goes unnoticed long after the occupant as left the bathroom.

FloodStop (FS 3/8-C) automatically shuts off the water supply to the Dishwasher or Toilet, whether caused by a small continuous leak, broken component, leaking seal, overflow or a ruptured supply line. Powered by AC Adaptor/Transformer or AA Batteries. Output contacts available, which allow the Controller to connect with Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in ten minutes.

FloodStop (FS 3/8-C) Components:

  • Motorized Ball Valve (3/8 inch Compression Fitting)
  • Control Unit (with Battery Backup 4 AA Size)
  • Water/Leak Sensor (1.25 X 7.5)
  • AC Power Adaptor (or use AA Batteries as Primary Power Source)
  • Output Contact Wires (1)

How FloodStop (FS 3/8-C) Works:

  • The FloodStop valve is connected to the angle stop and supply line
  • Water/leak sensor is placed at the base of the appliance or fixture (Dishwasher Toilet 3/8 Icemaker etc.)
  • Valve stays open until water loss is detected
  • Water on sensor closes FloodStop valve and sounds alarm
  • Valve stays closed until problem is attended to and system is reset

Wire Lengths:
Wiring Harness:

  • Controller to Sensor Wire Length: 7 feet
  • Controller to Valve Wire Length: 3 feet

Transformer: Wire Length: 6 feet

1 year warranty

Download the FloodStop Installation Instructions
stop-floods-from-dishwashers-and-toilets.html
$134.49

FloodStop 3/8-C For Dishwashers And Toilets
FloodStop 3/8-C For Dishwashers And ToiletsFloodStop 3/8-C For Dishwashers And Toilets
Item #FS38C
AvailabilityUsually ships the same business day
Sale Price$134.49
Quantity


Description

FloodStop For Dishwashers & Toilets
Water Leak Detection System - Protect Your Property Against Water Damage

Prevent water damage from failed Dishwasher or Toilet and Supply Line:

Dishwasher leaks are often small and go unnoticed until significant damage is finally discovered. Such a leak will continue to collect under the Dishwasher and then seep between the kitchen flooring and sub-flooring. The damage often goes undetected until the floor is visually buckled or warped, at which time the damage and cost to replace is extensive.

Toilet overflows can be the cause of significant property damage. The actual overflow event typically takes a couple minutes to begin and often goes unnoticed long after the occupant as left the bathroom.

FloodStop (FS 3/8-C) automatically shuts off the water supply to the Dishwasher or Toilet, whether caused by a small continuous leak, broken component, leaking seal, overflow or a ruptured supply line. Powered by AC Adaptor/Transformer or AA Batteries. Output contacts available, which allow the Controller to connect with Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in ten minutes.

FloodStop (FS 3/8-C) Components:

  • Motorized Ball Valve (3/8 inch Compression Fitting)
  • Control Unit (with Battery Backup 4 AA Size)
  • Water/Leak Sensor (1.25 X 7.5)
  • AC Power Adaptor (or use AA Batteries as Primary Power Source)
  • Output Contact Wires (1)

How FloodStop (FS 3/8-C) Works:

  • The FloodStop valve is connected to the angle stop and supply line
  • Water/leak sensor is placed at the base of the appliance or fixture (Dishwasher Toilet 3/8 Icemaker etc.)
  • Valve stays open until water loss is detected
  • Water on sensor closes FloodStop valve and sounds alarm
  • Valve stays closed until problem is attended to and system is reset

Wire Lengths:
Wiring Harness:

  • Controller to Sensor Wire Length: 7 feet
  • Controller to Valve Wire Length: 3 feet

Transformer: Wire Length: 6 feet

1 year warranty

Download the FloodStop Installation Instructions


FloodStop 3/8-C For Dishwashers And Toilets

Customers Who Purchased This item Also Purchased:

FloodStop Transformer Extension Wire
9' transformer extension wire, for use with FloodStop water leak detection products.
Sale Price: $14.15
FloodStop Additional Sensor
Additional sensor for FloodStop water leak detection system. Sensor can be daisy chained into each other for additional coverage. Each sensor comes with 1 meter wire.
Sale Price: $16.45
Controller to Valve Extension Wire For FloodStop Systems
For FloodStop water leak detection systems.
Sale Price: $14.15
BBBOnLine Reliability Seal RE Williams Shopper Ratings This shopping cart employs the highest industry strength security: 256 bit SSL E-commerce by Yahoo!
We accept Visa, Master Card, Discover, American Express, and PayPal
Copyright © 2014 REWCI.com. All Rights Reserved.